Description
Reference: GOUJFIXWEBER
- For inlet manifolds supporting Weber DCOE carburators, with M8 studs thread
Description:
- The studs length & design can accommodate spacers with O-rings (between carburetor and inlet manifold) and Cosworth type washers / rubbers located under the securing nut. The lower studs are longer to accommodate a linkage system.
Contains:
- 2 upper stainless steel studs, M8 on both side, total lenght 52 mm
- 2 lower stainless steel studs, M8 on both side, total lenght 54 mm
- 4 narrow M8 nyloc nuts
- The kit is for one DCOE carburetor
Note:
- It is recommanded to secure the studs in the manifold with medium strength Loctite or other securing compound.
If not, when removing the nyloc nuts that secure the carburetor, the studs will come loose
